Avatar

Selene Dunham

  • Total activity 23
  • Last activity
  • Member since
  • Following 0 users
  • Followed by 0 users
  • Votes 7
  • Subscriptions 6

Comments

Recent activity by Selene Dunham
Sort by recent activity Recent activity Votes
    1. Community
    2. Ask The Community
    3. Right Sidebar

    Dave Elfers I sent my feedback.  And my feedback involves “I'm looking for another platform.” I have been using Stack with four different companies over the last eight years. I've always loved Stac...

    1. Community
    2. Ask The Community
    3. Right Sidebar

    +1 to everything Chance CBC suggested for further improvements! Especially the ability to swap sidebar sides or move the tabs between the two sidebars!

    1. Community
    2. Ask The Community
    3. Right Sidebar

    Cristal Elias I actually meant resizing of both sidebars. The left sidebar has always been too wide for me. I've adapted but it's a lot more glaring now with the addition of the right sidebar.

    1. Community
    2. Ask The Community
    3. Right Sidebar

    Thanks, Cristal Elias ! I did notice the sudden appearance of the “start measuring” and “finish measuring buttons” which were very nice to see.It would be enormously helpful if you guys could allow...

    1. Community
    2. Ask The Community
    3. Right Sidebar

    I haven't done an actual takeoff with it yet. I need to today. Previously I was just trying to count unit types for a hotel I'm going to work on.  When I create a count take off I need to close it,...

    1. Community
    2. Ask The Community
    3. Cutouts

    Yes, Katie Blue , that is exactly what I am doing.  It is the exact same thing I have done to make cut outs for the past 8 years on Stack.

    1. Community
    2. Ask The Community
    3. Cutouts

    This has been driving me nuts, too! It used to be that you could select a measurement, then cut as many times as you wanted on the selected measurement. Now it closes it after each cut the same way...

    1. Community
    2. Ask The Community
    3. Count as Negative so useful!

    Full agreement, Peter Marakis ! For me it's not on the count tool but on the area and surface area ones.  Being able to do a change order by deducting footage as negative saves SO much time and eff...