Selene Dunham
Commentaires
-
Dave Elfers I sent my feedback. And my feedback involves “I'm looking for another platform.” I have been using Stack with four different companies over the last eight years. I've always loved Stac...
-
+1 to everything Chance CBC suggested for further improvements! Especially the ability to swap sidebar sides or move the tabs between the two sidebars!
-
Cristal Elias I actually meant resizing of both sidebars. The left sidebar has always been too wide for me. I've adapted but it's a lot more glaring now with the addition of the right sidebar.
-
Thanks, Cristal Elias ! I did notice the sudden appearance of the “start measuring” and “finish measuring buttons” which were very nice to see.It would be enormously helpful if you guys could allow...
-
I haven't done an actual takeoff with it yet. I need to today. Previously I was just trying to count unit types for a hotel I'm going to work on. When I create a count take off I need to close it,...
-
Yes, Katie Blue , that is exactly what I am doing. It is the exact same thing I have done to make cut outs for the past 8 years on Stack.
-
This has been driving me nuts, too! It used to be that you could select a measurement, then cut as many times as you wanted on the selected measurement. Now it closes it after each cut the same way...
-
Full agreement, Peter Marakis ! For me it's not on the count tool but on the area and surface area ones. Being able to do a change order by deducting footage as negative saves SO much time and eff...